Aker Model 500D Double Handcuff Case

Item Code: A500D
Available
Description
  • Made in the USA
  • Full Grain Vegetable Tanned Leather
  • Fits 2 Pairs of Chain or Hinged Handcuffs
  • Slides Onto Duty Belts up to 2-1/4"
  • You May Also Like


    Detail
    Reviews / Q&A
    Detail

    The Aker Leather model 500D Double Handcuff Case features a round design and fits two pairs of handcuffs to save space on duty belts. Fits two pairs of hinged or chain link handcuffs, including the Smith & Wesson Model 100 and Model 1 handcuffs and the Peerless 700C, 730C, and 801C. Inside is a leather separator with a finger cutout for quick access to both handcuffs.

    Hand crafted from the highest grade of full grain vegetable tanned leather and uses heavy-duty nylon bonded thread. The case is available in plain or basketweave and finished with a sewn Velcro hook and loop closure. A dummy snap is available upon request to meet uniform requirements, though it is non-functional. Two pre-molded belt slots on the rear allow the handcuff case to easily slide onto duty belts with up to a 2-1/4" width. Each slot is angled inward so that your case stays secure on the belt and does not sag or move around.

    Many law enforcements agencies, including the Contra Costa County sheriff department, provide this double handcuff case to their officers for use on duty.

    Features & Specs:

    • Round double handcuff case
    • Made in the USA using full grain vegetable tanned leather
    • Fits two pairs of chain or hinged handcuffs
    • Slides easily onto duty belts up to 2-1/4"
    • Approved by the Contra Costa County Sheriff Department
    WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

    Reviews / Q&A


    Customers who bought this also bought


    Best Sellers