ZEV Technologies Fits Glock 4th Gen (9mm/40SW/357SIG) Slide Release Part Black Extended Mag Release

Item Code: ZT-MAGRELEASE-4G-S
Out of Stock
Email me when in stock
See More

    You May Also Like


    Detail
    Reviews / Q&A
    Detail
    The ZEV Technologies Fits Glock 4th Gen (9mm/40SW/357SIG) Slide Release Part Black Extended Magazine Release is constructed from Billet 6061 Aluminum and Mil Spec hard anodized Black. It has a checkered non-slip face;for a more tactile engagement surface. The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes. The Mag Release takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver. ZEV Parts always incorporate design, feel and performance.

    Fits:

  • 4th Gen Glock 17, 19, 22, 23, 26, 27, 31, 32, 33, 34, 35, and 37

  • *Note: It is easiest to remove and replace the factory Glock; Mag-release Catch Spring for the magazine release installation. Then installing it back in its pin position after you remove the factory unit and replace it with the ZEV component.
    ZEV Technologies Fits Glock 4th Gen (9mm/40SW/357SIG) Slide Release Part Black Extended Mag Release
    PayPal is not available as a payment option for this product.
    WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

    Reviews / Q&A


    Customers who bought this also bought


    Best Sellers