The ZEV Technologies Fits Glock 4th Gen (10mm/45ACP) Slide Release Part Black Extended Magazine Release is constructed from Billet 6061 Aluminum and Mil Spec hard anodized Black. ZEV Parts always incorporate design, feel and performance. The Mag Release takes minutes to install with the use of needle nose pliers and a long shaft, slim, flat head screwdriver.
Honeycomb non-slip face for a more tactile engagement surface.
The contact point on the mag release face is ergonomically angled to the rear to allow ease of manipulation in performing magazine changes
4th Gen Glock 20, 21, 29, 30, 40, 41
*Note: It is easiest to remove and replace the factory Glock; Mag-release Catch Spring for the magazine release installation. Then installing it back in its pin position after you remove the factory unit and replace it with the ZEV component. ZEV Technologies Fits Glock 4th Gen (10mm/45ACP) Slide Release Part Black Extended Magazine Release
PayPal is not available as a payment option for this product.
WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.