The Wheeler Engineering 89-Piece Professional Gunsmithing Screwdriver Set is the kit that belongs on every gunsmithing bench - the well thought-out bit selection will put an end to burred, buggered, busted up screw slots on any gun that comes your way.
The bits make up the heart of any screwdriver set, and Wheeler's are the finest available. They're made from S2 tool steel and hardened to 56-58 Rockwell "C." Unlike other screwdriver suppliers,Wheeler's engineers measured the screws on over one hundred modern and antique firearms to make sure that we offered bits for every situation.
Whether you're working on a Browning Superposed, a Remington 700, a Smith & Wesson revolver, or a Colt Single Action, you'll find that there's a bit to fit every screw on your gun. The 54 Hollow-ground flat bits range in size from .120"x.020" to .360"x.070", and includes doubles in the thinnest sizes.
The set also includes a complete selection of Phillips, Allen, and Torx bits to cover scope rings, bases, recoil pads, and the like. Also comes with two handles made from comfortable overmolded plastic. The first is a regular size handle that's good for most jobs, and the second is a slimmer, shorter "Close Quarters" handle that is good for finesse work with smaller bits.
Case Size: 8"x12"x3"
Bit Material: S2 Tool Steel
Bit Hardness: 56-58 Rockwell C
Driver Handles: 2, with magnets
Extension: 1, 3" with magnet
Adapter: 1 Hex to square drive
Flat Bits: 54 Hollow-Ground
Allen Bits: 8
Phillips Bits: 4
Torx Bits: 3
Specialty Bits: 15
Battenfeld Product Item Number #562194 Wheeler Engineering 89-Piece Professional Gunsmithing Screwdriver Set
PayPal is not available as a payment option for this product.
WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.